Rapid-cycle heating for packaging lines
From seal bars to hot-melt applicators and shrink tunnels — MAHC engineers the thermal control your packaging lines run on.
Heat fast, hold tight, cycle clean
Packaging runs at speed. A half-degree overshoot on a seal bar means rejects; a slow warm-up on a hot-melt tank means downtime. MAHC provides the elements, sensors and controls that keep packaging thermal processes right on setpoint.
Seal Bars & Strip Heaters
High-watt-density band and strip heaters for pouch, blister and clamshell sealing — fast recovery between cycles, tight ±2°F control.
Hot-Melt Tanks & Applicators
Cartridge and cast-in heaters for melt pots, hoses and nozzle tips — zone-controlled to maintain viscosity without scorching adhesive.
Shrink Tunnels & Ovens
Radiant or convective heaters with multi-zone PID for film shrink, label application and sleeve wrapping at line speed.
Labelers & Case Sealers
Thermal transfer and wax-resin ribbon heater control, glue pot temperature regulation and hot-air knife heating.
Where packaging meets heat
- Form-fill-seal (FFS) pouch machines
- Blister & clamshell sealers
- Shrink-wrap and sleeve applicators
- Hot-melt case sealers and carton closers
- Thermal inkjet and transfer coders
- Corrugated box glue application
- Flexible film perforation and corona treatment
Packaging thermal FAQ
With the right watt-density and thermal mass, recovery times under 2 seconds are achievable. We select heater mass and control output (SSR with phase-angle firing for fastest response) based on your cycle rate and dwell time.
Yes. We specify 316L stainless sheaths, FDA-compliant coatings, and sanitary designs where heater surfaces may contact packaging or food contact surfaces. We'll match your regulatory requirements.
For high-speed applications we use low-thermal-mass elements (thin ceramic bands, thick-film heaters) with fast-response RTDs and SSR/SCR power switching to minimize lag. PID tuning is optimized for your cycle time during commissioning.
Absolutely. We can retrofit pot, filter, hose and applicator zones with independent controllers and matched heaters — reducing scorch risk and adhesive waste across the whole system.
Speed means nothing without heat control.
Rapid-cycle sealers, hot-melt applicators, shrink tunnels — MAHC keeps your packaging thermal on spec.
Get a Quote